Connect with us

Roberts 1725-8III channel bleed

Discussion in 'Troubleshooting and Repair' started by SquireRic, May 2, 2009.

  1. SquireRic

    SquireRic

    2
    0
    May 2, 2009
    I picked up a Roberts R2R 1725-8III and the right channel and line out ports dig not work. I replace all three of the 6AR5 tubes and corrected some of the problem. I do get some sound from the right channel but I also get a lot of hiss as if a transister or capacitor is bleeding or shorting out. Since the board they are on is such a hard one to service, does anyone have any ideas what approach I should take. It is near impossible to get to the legs of the transisters.
    Thanks.
    Ric
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-