Connect with us

RMS currents...and microsim 8.0

Discussion in 'CAD' started by Rahan, Aug 15, 2003.

Scroll to continue with content
  1. Rahan

    Rahan Guest

    Hi,
    it´s not a joke, I start to "use" microsim 8.0 I have a big impedance
    network and would like to see the RMS values of the currents flowing through
    some wires.
    But, for the moment (sic), I didn´t succeded encountering the following
    problems:
    - I just found "bias current probes" which are not helpful with a
    traditional 50Hz (60) signal, but I´m able to see the signals using probe
    resulting to a graph....(wow)
    - The circuit include inductors and current sources, I would like to see the
    currents value (like reading an amperemeter) when a steady state has been
    reached

    So can one or more microsim user tips me on how to get *RMS* currents
    indication on my schematic (don´t laugh) when *the steady state is reached*

    Any help will be greatly appreciated

    J-M
    Sweden (just in case, for a beer...)
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-