G
Glenn Ashmore
- Jan 1, 1970
- 0
I am a bit worried that my pair of Danfoss BD50 compressors are going to put
out a lot of RFI so am working to isolate them by lining the compartment
with foil and putting common mode chokes on the power lines. I have found a
lot of chokes that can handle the current but they come in a variety of
inductances. How do you figure out which value to use? Especially when the
compressor will run at different speeds.
--
Glenn Ashmore
I'm building a 45' cutter in strip/composite. Watch my progress (or lack
there of) at: http://www.rutuonline.com
Shameless Commercial Division: http://www.spade-anchor-us.com
out a lot of RFI so am working to isolate them by lining the compartment
with foil and putting common mode chokes on the power lines. I have found a
lot of chokes that can handle the current but they come in a variety of
inductances. How do you figure out which value to use? Especially when the
compressor will run at different speeds.
--
Glenn Ashmore
I'm building a 45' cutter in strip/composite. Watch my progress (or lack
there of) at: http://www.rutuonline.com
Shameless Commercial Division: http://www.spade-anchor-us.com
