Connect with us

Resister help needed

Discussion in 'Beginner Electronics' started by mike urig, Dec 29, 2007.

Scroll to continue with content
  1. mike urig

    mike urig Guest

    I want to reduce the voltage from 1.5 volts to 1.0 - .90 volts.
    What resister would do this and what end goes toward to 1.5 volt side?
    Thanks
     
  2. mike urig

    mike urig Guest

    The voltage drop will tell an onboard motorcycle computer to richen the
    fuel ratio a little more than stock. The signal comes from an O2 sensor
    in the exhaust header pipes. I'm just trying to reduce the voltage a
    little more than stock.

    You can go here: http://www.nightrider.com/parts/
    hd2007HD_nbo2_voltage_divide.htm and read the part about "Testing the
    NBO2 Inline Enrichment Device off the bike".
     
  3. mike urig

    mike urig Guest

    Never mind, I found the schematic.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-