Connect with us

Reading analog input and writing 2 bytes simultaneously in the microcontroller

Discussion in 'Microcontrollers, Programming and IoT' started by Ignatius, Jun 23, 2017.

Scroll to continue with content
  1. Ignatius

    Ignatius

    1
    0
    Jun 23, 2017
    Hi,

    I have project to control DC motor to replace the manual parking brake in the four wheeler. To develop a prototype I have decided to use a labview software communicating with the microcontroller. My intention is that I need to read one of the analog inputs continuously where the motor current signal will be connected at the same time set the forward and reverse motor current limits from the labview.
    I know this is not possible with the serial communication. I would like to know whether this can be achieved using TCP/IP so that I can display the motor current continuously in the graphical representation as well as set the current limits from the labview.

    If this is possible, pls help me with the controller number, if possible with the simple microcontroller code.

    Regards,
    X. Ignatius
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-