Maker Pro
Maker Pro

RCA Television Sound Problem

H

hoggboy

Jan 1, 1970
0
Yesterday while watching television the sound went bad. By bad, I mean the
sound is now garbled with a lot of noise to the point that the program can
not be heard. When trying to troubleshoot the problem, I discovered that
the sound problem was only present when the program source was throught the
coax port. When bringing audio in through the RCA jacks, the sound was
clear.

Any suggestions how to fix this problem?
 
S

Sofie

Jan 1, 1970
0
hoggboy:
I know that it is obvious to you that not all RCA television models have the
same features, circuitry and components so you really should post the MODEL
NUMBER and CHASSIS NUMBER if you are hoping for anything close to a specific
repair suggestion.....
First you should check the Menu settings for the audio. If this is a stereo
television, be certain that it is not in the SAP mode..... also try
switching to the mono mode... and try a variety of different channels.
Inside the television circuitry there could be component failures that will
need proper testing and troubleshooting by an experienced and knowledgeable
technician with the proper test equipment and tools....... if you are not
prepared to do that I would suggest that you TAKE your television to a
service shop for at the very least a repair cost estimate so you can make an
intelligent repair decision with facts instead of internet or telephone
guesses.
 
Top