Maker Pro
Maker Pro

RCA PTK195M1A pincushion question

G

Guest

Jan 1, 1970
0
Hi. Got an RCA PTK195M1A bigscreen set here. Replacing convergence power
supply with new version resolved the lack of convergence, but pincushion is
off a bit all the way around towards the edges. Not terrible but obvious. I
have seen scattered references to minor adjustment of pincushion through
service menu if Chiiper Check is not available. I don't have it yet.

My question is this, if you have a moment, and perhaps the book for this
set. Just a quick rundown on service menu codes for pincushion. I am
familiar with RCA service menus and how to enter them, but haven't done that
on one of this version. Around here I still get many 169 proj sets but not
many 195 sets.

Thanks much,

Danny
 
Top