X
xxx
- Jan 1, 1970
- 0
Perhaps some of you seasoned pspice users can help me.
I have a 74hc165 parallel to serial data converter to
simulate. Basically I would like to be able to look
at the bit output pattern from the ser pin on the device.
Typically serial data is clocked out of this part. IM
Stuck as to where to begin in setting up my circuit
from a simulation standpoint as I have not worked with
digital circuits in p-spice.
If any of you would happen to have a p-spice 8 schematic
of the above and are willing to share it, I would be
grateful for your help.
Thanks..Dave.
I have a 74hc165 parallel to serial data converter to
simulate. Basically I would like to be able to look
at the bit output pattern from the ser pin on the device.
Typically serial data is clocked out of this part. IM
Stuck as to where to begin in setting up my circuit
from a simulation standpoint as I have not worked with
digital circuits in p-spice.
If any of you would happen to have a p-spice 8 schematic
of the above and are willing to share it, I would be
grateful for your help.
Thanks..Dave.
