PS transf. to heat sink glue?

[JackShephard]

So you don't think there is any thermal conductive property to the original
stuff?

Get some silica powder or fiberglass shards to add to it to increase the
thermal properties.

 

[JackShephard]

Besides, filled adhesives aren't all that much better than unfilled
ones, even if the filler is diamond.

You're full of shit.

 

[JackShephard]

I made some measurements on Araldite filled with copper filings to quite
a high density, basically as much copper as I could get in there and
keep it workable. The heat transfer through it was amazing. I was quite
impressed.

Then my techie did the same tests with plain Araldite and the results
were a few percent worse. It actually made hardly any difference. So
you're bang on.

I would say that those "tests" were flawed then, as were the results,
and likely, the methods.

 

[Michael A. Terrell]

You're full of shit.

Go away Massive Dingdong. Everyone knows that you've Morphed, again.



--
Service to my country? Been there, Done that, and I've got my DD214 to
prove it.
Member of DAV #85.

Michael A. Terrell
Central Florida

 

[JackShephard]

Go away Massive Dingdong. Everyone knows that you've Morphed, again.

You do not get to tell me what to do here or anywhere else, you sub-E-1
grade dumbfuck.

 

[John Larkin]

You're full of shit.

But you're AlwaysWrong.

John