Connect with us

prowatt 3000 inverter problem

Discussion in 'Troubleshooting and Repair' started by epanzella, Aug 26, 2009.

Scroll to continue with content
  1. epanzella

    epanzella

    4
    0
    Aug 26, 2009
    I have a ZANTEC PROWATT 3000 inverter whose input was momentarily hooked up to reversed polarity 12vdc. Small pop, then dead as a doornail. I've been trying to get a schematic thru Zantec but I have yet to talk to anyone, just hours of elevator music. Any have some incite on this? Thanks.
     
  2. powerryder

    powerryder

    1
    0
    May 8, 2013
    xantrex reverse power 12vdc

    OK, sorry to hear you reversed the input 12vdc power to the xantrex. You blew the internal fuses. If you take the case apart you will see the blow fuse. Might need to soldier out old and in with the new.
     
  3. epanzella

    epanzella

    4
    0
    Aug 26, 2009
    Wow, this thread is almost 4 years old!. Anyhoo, there was ten 25 amp fuses inside, all toast. They were automotive fuses but soldered in. Changed 'em and it's been working fine ever since. Thx 4 responding.
    Ed
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-