Connect with us

Proteus Simulation

Discussion in 'Radio and Wireless' started by JVMAPPY, Jul 16, 2020.

Scroll to continue with content


    Jul 16, 2020
    Hello Engineers;
    I am currently designing a transmitter-Receiver wireless remote control mini project using Proteus 8.0
    During simulation I had three errors:
    1. 'Cannot find model RX MDF'
    2. 'Cannot find model TX MDF'
    3. Simulation failed due to netlist error.

    With some research I attached the Rx and Tx as Hierarchy module and the error was gone.

    My only error now is " Simulation is not running in real time due to excessive cpu load"

    I have closed all other programs running and my laptop spec is 64bit, 8gb Ram, 1Tb HDD.

    Any help to resolve this will be well appreciated.

    Attached Files:

    • 1.PNG
      File size:
      45.7 KB
    • 2.PNG
      File size:
      4.7 KB
  2. Harald Kapp

    Harald Kapp Moderator Moderator

    Nov 17, 2011
    So what? Is that truly an issue?
    Simulations rarely run in real time as it takes multiple instructions the cpu to simulate a single step in time of a circuit.
    Typically you simulate a circuit, record the simulation results and analyze the results later leisurely.

    When you enter that message into your favorite search engine you will find that many people had the same issue - and received similar answers, even here on this forum.
    It is always a good idea to first search what others may have to say on an issue before starting a thread.
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads
There are no similar threads yet.
Electronics Point Logo
Continue to site
Quote of the day