Connect with us

Protel SE99

Discussion in 'PCB Layout, Design and Manufacture' started by Explore3208, Dec 3, 2018.

  1. Explore3208


    Dec 3, 2018
    Spent 2 hours trying to get the DRC "Clearance Constraint" to provide an error when two pieces of copper are too close. Can't make it work. It works for Component Clearance. Any thoughts?
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads
Electronics Point Logo
Continue to site
Quote of the day