Maker Pro
Maker Pro

ProScan PTK171 Pincushion/Width problem

B

BWL

Jan 1, 1970
0
This set had a bad H.V. Block, which I replaced after a 6 month backorder;
customer says pic was normal prior to going out. Now the Pincushion and width
controls on rear right of chassis assy are inop, an pic is too narrow, and
bowed in on sides. Convergence working normally. I know this is a pretty rare
chassis (I've never worked on one before) Has anybody had one of these with
this problem. If not, I'll order the schematics through schematics.com ($25.50
in paper).

TIA
Billy
 
J

Jerry G.

Jan 1, 1970
0
I would first investigate for high ESR caps in the pin and scan areas. This
is a common fault in many sets.

--

Greetings,

Jerry Greenberg GLG Technologies GLG
=========================================
WebPage http://www.zoom-one.com
Electronics http://www.zoom-one.com/electron.htm
=========================================


This set had a bad H.V. Block, which I replaced after a 6 month backorder;
customer says pic was normal prior to going out. Now the Pincushion and
width
controls on rear right of chassis assy are inop, an pic is too narrow, and
bowed in on sides. Convergence working normally. I know this is a pretty
rare
chassis (I've never worked on one before) Has anybody had one of these with
this problem. If not, I'll order the schematics through schematics.com
($25.50
in paper).

TIA
Billy
 
Top