Connect with us

Programming AT90s1200-12 for car gear selection

Discussion in 'Microcontrollers, Programming and IoT' started by shifteh, May 8, 2011.

  1. shifteh

    shifteh

    1
    0
    May 8, 2011
    hi
    so basically gearbox has 7 solenoids to control gear selection, solenoids 1 and 2 are the gear selection

    1st gear: Both S1 and S2 on
    2nd gear: S2 on
    3rd gear: both off
    4th gear: S1 on

    i need to program the AT90s1200-12 so that i can have 2 switches (v+) (v+) that dependinf on which pin it is switch the solenoids , like up and down gears

    any ideas? :D
     
Ask a Question

Want to reply to this thread or ask your own question?

You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-