Connect with us

Problems with my one shot.

Discussion in 'Electronic Design' started by Genome, May 4, 2005.

Scroll to continue with content
  1. Genome

    Genome Guest

    It appears to set itself, eventually it resets itself.

    Unfortunately there is no output.

    It's interfaced to my neural network.

    Unfortunately, I have to interface it to someone elses neural network and
    I'm suffering feedback problems with information gathered by other sensors
    and probes which tend to generate interrupt service requests at a rate that
    takes up all my processing time.

    The target system seems happy. In fact it's quite robust.....

    It enters power saving mode after about two hours of interfacing but then
    there's a problem with its sound subsystems. It also tends to rob resources
    when in power saving mode.

    Any advice?

    DNA
     
  2. No, no, professor. You have to plug in the _female_!
    -- Porgy. Or was it Mudhead?
     
  3. I'll bet the target system, like most, has a re-triggerable
    multivibrator. Perhaps if, rather than neural networks, you apply
    fuzzy logic and ethyl alcohol, and then interfaced to the linguistic
    (or lingual) variables, followed by a thorough defuzzification and
    rinse in DI water.


    Best regards,
    Spehro Pefhany
     
  4. John  Larkin

    John Larkin Guest

    A flipflop usually fixes intermittent low-frequency noise problems.
    Try forced inversion.

    John
     
  5. I read in sci.electronics.design that Genome <>
    Have you tried adding a GRA to V1A?
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-