Maker Pro
Maker Pro

Problem identifying a component value Conext 60 150 MPPT charge controller.

Ron Bailey

Feb 17, 2021
2
Joined
Feb 17, 2021
Messages
2
I am trying to replace what I believe to be a Schottky Rectifier.
The black line circling the 4 schottkys is where I am working.
I cannot find any info online, or a schematic for this unit.
I would like to select a suitable replacement.
Thanks for any help
Update:
I removed the suspect component and it seems to work as it should.

My controller boots up and looks normal except it shows no amps or watts coming in from solar.
 

Attachments

  • 20210213_073416.jpg
    20210213_073416.jpg
    93.5 KB · Views: 6
  • 20210213_073327.jpg
    20210213_073327.jpg
    90.1 KB · Views: 5
Last edited:

73's de Edd

Aug 21, 2015
3,613
Joined
Aug 21, 2015
Messages
3,613
https://datasheet.octopart.com/10BQ040PBF-Vishay-datasheet-9803539.pdf


Page 2 . . .at end of . . . . THERMAL - MECHANICAL SPECIFICATIONS . . .re the assignmeent of the Vf1 marking code.

Looks like you have 4 green pass transistors and their associative / isolative Surface Mount steering diodes .
If using a DVM's "diode test" mode, with its meager test current being utilized, looks like 400-500 mv might be in order, in considering the upward sliding spec of a more typical 1A and 25-125 deg temp shift in real time operating conditions.
PLUS . . . . . that photo is far too small and of too poor of definition to extract any meaning from it, as well as the omitted other board side.
 
Last edited:
Top