Connect with us

Printed Circuit Boards

Discussion in 'Electronic Basics' started by Richard Harris, Jan 18, 2005.

Scroll to continue with content
  1. Hi,
    Im looking for a way to print on the top side of a single layer PCB,
    Displaying R values, box's and other information so its simple to see where
    comonents go when assembling the board. Im using photo resist boards. Any
    ideas would be great. I can't think of any easy way to do it.

    Thanks for ya time.
     
  2. Bob Masta

    Bob Masta Guest

    How about the same heat-transfer film that's normally used
    to make the resist patterns on the copper-clad side?




    Bob Masta
    dqatechATdaqartaDOTcom

    D A Q A R T A
    Data AcQuisition And Real-Time Analysis
    www.daqarta.com
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-