Connect with us

primary currents in pspice 9.1

Discussion in 'CAD' started by Danny, Dec 15, 2005.

Scroll to continue with content
  1. Danny

    Danny Guest

    primary 0.01ohm and 10mH, secondary 40000mH. secondary connected to
    different rectifier types. in every damn case the voltages are exactly
    as predicted. what i can't understand is why the primary current dc
    value tendes to rise to ridiculous values of kAmperes over the
    simulation time. Vsin=10V, 0offset at 50Hz.

    i've doctored the BIV of the 1n4002 diodes to 50000 volts.

    many thx for any help

    Danny.
     
  2. Danny

    Danny Guest

    I come in Monday morning, run the simulation again and everything is
    hunky dory. Go figure!

    thx anyways

    Danny
     
  3. Jim Thompson

    Jim Thompson Guest

    That's the way life always is ;-) Good luck!

    ...Jim Thompson
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-