Connect with us

Power Supply with an output of 12V using Silicon Controlled Rectifier?

Reply to Thread

Discussion in 'Power Electronics' started by DiegoSilang, Jan 16, 2016.

Scroll to continue with content
  1. Jan 16, 2016 #1
    DiegoSilang

    DiegoSilang

    1
    0
    Jan 16, 2016
    [​IMG]
    Hello. I'm trying to resolve this circuit simulation by means of Multisim. Is there any problem with the connections? Somehow the fuse always breaks. I'm trying to get an output of 12V using scr + 4n25 optocoupler. Also, I'm trying to construct an actual circuit using this simulation. Any help would be much appreciated.

    The 0.24ohm resistor is the assumed load.

    I presume the output of the trigger is correct. I just copied the circuit diagram with little knowledge of it thinking it would produce a 12V output from AC to DC. Can you help me resolve the directions of the wrongly positioned SCRs?
     
  2. Jan 16, 2016 #2
    dorke

    dorke

    2,342
    665
    Jun 20, 2015
    And it should break !
    You have V221=220Vrms connected through the "fired SCRs" to the load of R14=0.24ohm and the fuse is 1A.
    Try to calculate the current you get through the fuse...:rolleyes:

    Besides,
    What is it you wish to do ,and why do you need the SCRs for?
     
  3. Jan 17, 2016 #3
    (*steve*)

    (*steve*) ¡sǝpodᴉʇuɐ ǝɥʇ ɹɐǝɥd Moderator

    25,505
    2,852
    Jan 21, 2010
    I remember many moons ago there was a circuit for what was essential a switching regulator using an SCR.

    Of course, since it pretty much operated by letting through entire half cycles at twice the mains frequency, it had pretty hopeless characteristics.

    I'll take a closer look at the circuit when I have a larger screen to see if that is the idea. For practical purposes it's not a design you would contemplate with a low impedance power source and load.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads

  1. Power supply help wanted with bridge rectifier.

  2. Audio controlled power supply

  3. Question about a rectifier PCB of a welding power supply

  4. 0-60VDC POWER SUPPLY CONTROLLED BY 0-5VDC

  5. Project: Speech controlled power supply and signal generator

  6. 12V input to 3 fixed voltage levels output, controlled by a pushbutton.

  7. 12 pulse rectifier output and filter circuit

  8. Best Motor Option for an Arduino Controlled trolley

Loading...
Electronics Point Logo
Continue to site
Quote of the day

“”

-