Connect with us

Power Supply for LM3886T.

Discussion in 'Electronic Basics' started by Mike, May 28, 2004.

Scroll to continue with content
  1. Mike

    Mike Guest

    Hi!
    I'm trying to build an audio aplifier using two LM3886s, and since i'm a
    beginner im not quite sure what kind of power
    supply do i need to build to power the LMs up. Schematics or any hints will
    be very appreciated!!
    Thank you!!

    Mike
     
  2. These power amplifiers do not usually need anything fancy in the way
    of a supply. You need a transformer with a center tapped secondary
    (somewhere around 48 volts total) (or two 24 volt windings you hook in
    series) rated for a few amps. Add a bridge rectifier across the whole
    secondary and a couple big capacitors (10,000 to 20,000 uf, @ 50
    volts), each connected to one of the bridge DC outputs and the other
    end to the center tap. Ground the center tap. Don't forget to put a
    fuse in the primary. This will provide about + and - 33 volts.

    This sort of transformer comes up on ebay quite often. Shipping can
    be steep, though.
    http://cgi.ebay.com/ws/eBayISAPI.dll?ViewItem&category=4665&item=3818219482
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Similar Threads
There are no similar threads yet.
Loading...
Electronics Point Logo
Continue to site
Quote of the day

-