Connect with us

plasma tv fault

Discussion in 'Electronic Repair' started by Nick Williams, Nov 22, 2007.

Scroll to continue with content
  1. Can anyone point me in the right direction please?
    On an Orion Electric 'Vision PM4204' plams monitor I have the top half of
    the screen working fine, but the bottom half changes intermittently between
    total black and correct picture. What are should I be looking in
  2. James Sweet

    James Sweet Guest

    If you're lucky, a loose connector or cracked solder joint, otherwise you
    should be looking at a new set. Does it respond to tapping, temperature, or
  3. Hi James, thanks for your reply, at least yours is sensible. It may be
    temperature dependent, but it's hard to tell. Fortunately I have been given
    the set, so I am not to bothered if I can't fix it.
  4. Guest

    Look at the Y drive. If you don't have service data good luck, in
    fact good luck anyhow because most of these no name sets are not meant
    to be fixed when they break. Parts are just not available. If you're
    a tech then you'll pull your hair but maybe the IPM is bad, you could
    just sub parts out.
  5. Max

    Max Guest

    its X drive board or drivers after this board.check the boards that is
    connected directly to the screen by flexible cable.Some IC chips drivers
    could be bad.Try to swap them for example bottom boards on top and top
    to bottom and see what happens.If its will be the same replace
    X-board(the huge board usually on the right hand side of tv if you will
    see directly on back cover of tv)If you cannot find it I can help you.I
    need just brand of tv,model and serial number.Thanks
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day