Connect with us

Pioneer PDP-V401e plasma troubles

Discussion in 'Electronic Repair' started by Justin, Aug 18, 2004.

Scroll to continue with content
  1. Justin

    Justin Guest

    i'm looking for the service manual for a Pioneer PDP-V401e plasma display.

    or alternative - a way to repair the Y drive assembly.
    the story goes - i had a white band across the bottom 1/4 of the screen.
    i sent the display off and found out that an opto-coupler had failed, there
    are 12 of these on the board (PC911). the screen was returned and the white
    band continued to show itself. the following day the screen smoked. i
    removed the y drive assembly and found that the two hybrid IC's had burnt,
    they are HY6800 parts.

    i am looking to get hold of the service maual so that i can see what
    voltages should be present as i replace the faulty components... anyone got
    one...
     
  2. Art

    Art Guest

    Are you certian that the unit is not deemed board servicable? Many of the
    Plasma Sets are normally serviced in that manner.
     
  3. David

    David Guest

    Service manual contains a BLOCK diagram for the set except for minimal
    parts information on the power supply board. The set is BOARD level
    repair, exchange through Pioneer. The optoisolator failure is an
    engineering defect and ALL the y driver boards need replaced with the
    updated ones if it has the old ones.

    Pioneer US has been supplying those boards no charge to authorized
    servicers for repair for a long time when the customer calls the
    customer service number. Catch, no Pioneer help for sets that someone
    had tried to repair the boards or an unauthorized servicer attempted a
    repair.

    David
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-