Connect with us

PEAVY STANDARD 1978 MARK III SERIES 260D

Discussion in 'Electronic Repair' started by [email protected], Apr 23, 2007.

Scroll to continue with content
  1. Guest

    Hi:

    I have a PEAVY STANDARD 1978 MARK III SERIES 260D I want to sell it
    but I need to fix it first.

    Problem when I turn on the amp (connected to a peavy 4x 10 ((actaully
    2 Suns (8Ω) and 2 orig. peavys speakers)) cabinet) I get a loud WHACK
    of dc to the speakers. I disconnected the pre amp from the mains and
    the whack is much less more like normal (on a bench test speaker).
    Any ideas? I checked the the 2 BJT's and cleaned all pots and checked
    1/4 inch jacks. Any Schematics would be nice.

    Please Email me ASAP.

    thanks

    db
     
  2. DaveM

    DaveM Guest

    Hi:

    I have a PEAVY STANDARD 1978 MARK III SERIES 260D I want to sell it
    but I need to fix it first.

    Problem when I turn on the amp (connected to a peavy 4x 10 ((actaully
    2 Suns (8?) and 2 orig. peavys speakers)) cabinet) I get a loud WHACK
    of dc to the speakers. I disconnected the pre amp from the mains and
    the whack is much less more like normal (on a bench test speaker).
    Any ideas? I checked the the 2 BJT's and cleaned all pots and checked
    1/4 inch jacks. Any Schematics would be nice.

    Please Email me ASAP.

    thanks

    db

    Owners manuals and schematics, not available on the website, may be obtained by
    mail (via check or money order) or by phone (via credit card). Schematics are
    $2.50 per copy, owners manuals are $7.50 (paper back) / $20.00 (notebook).

    Send Check/Money order to: Peavey Electronics, Parts Department, PO Box 412 Hwy
    11 and 80, Meridian, MS 39301. Credit Card orders phone: (601) 483-5365. This
    applies to US and Canadian residents only.


    --
    Dave M
    MasonDG44 at comcast dot net (Just substitute the appropriate characters in the
    address)

    Life is like a roll of toilet paper; the closer to the end, the faster it goes.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-