Connect with us

PCB Coating

Discussion in 'General Electronics Discussion' started by Viktor, Oct 29, 2018.

Scroll to continue with content
  1. Viktor

    Viktor

    21
    1
    May 8, 2017
    I've been trying to dissolve a coating on a PCB.

    First, I thought it might be some type of silicone, so I bought very expensive silicone dissolve bottles, but it did not dissolve the coating at all.

    Honestly, I'm not sure what the material could be at this point, so thought I'd ask some people if they have a suggestion.

    Here's a picture of the thick coating.

    [​IMG]
     
  2. 73's de Edd

    73's de Edd

    3,063
    1,299
    Aug 21, 2015
    SIR Viktor . . . . .


    Potted and cured silicone rubber. . . .non soluble.

    A wooden spudger stick and selective removal is permissible on select smaller areas.
    Such as you have already done at the left area.

    Also some wetting as shown below, in his dipping the RED silicone potted connector, may help
    Reference . . . . .


    73's de Edd
    .....
     
    Richard9025 likes this.
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-