Connect with us

passing variables in Agilent ADS

Discussion in 'Electronic Design' started by Phil Newman, Nov 22, 2006.

Scroll to continue with content
  1. Phil Newman

    Phil Newman Guest

    Hi, I'm using Agilent ADS 2003C, and I would like to know how to pass
    variables from the work space into the data display window.

    Basically, i'm simulating s-parameters over 100-500MHz, and in one
    display graph, I want to observe the data over 225-250MHz, which is
    specified as a variable in the workspace.

    How can I get the graphs to automatically resize to the observed data
    best?

    It seems to me that the ADS display windows isn't very flexible for
    this.

    Regards,

    Phil
     
  2. aaronsky12

    aaronsky12

    1
    0
    Aug 24, 2009
    How to pass a variable in Agilent ADS to the Data Set

    First you need a simulation controller... For example, if you are simulating S-parameters you would insert a S-parameter controller into the schematic with a start, stop, step, etc. Then double click on the simulation controller and click on the output tab... Here is where you choose which particular variables you want to pass to the data set.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-