Maker Pro
Maker Pro

Parts for Ewave Microwave Oven?

M

Mistress

Jan 1, 1970
0
We have an Ewave (Daewoo/Magic Chef) KOT-152UW microwave oven purchased
at Home Depot. The touchpad is getting flakey and I have been trying to
locate a parts vendor without much success.

I'd appreciate any recommendations. Thank you.

(Yeah, I realise the touchpad may cost as much as a new oven but I
practically remoodeled the kitchen to fit this thing in.)
 
M

Mr. Land

Jan 1, 1970
0
This isn't much help, I'm afraid, but I'll post it because I'm sure
someone else will if I don't:

Be VERY careful working on this thing yourself. Uwaves are dangerous
to work on. I'm not talking about inadvertantly cooking your hand, I'm
talking about getting a shock strong enough to kill you. I'd google
the groups here, perhaps on "repair" and "microwave". Apologies for
possibly telling you what you already know, but better safe than sorry.

I'm curious: is this an odd-sized unit? Is that why you can't replace
it with another brand?

Good luck...
 
J

JANA

Jan 1, 1970
0
These types of microwave ovens are not supported for service. They are
"throw-always". Whenever modeling a kitchen for appliances, it is normally
done in a way to have the dimensions fitted to be able to accommodate the
range of available sizes. It looks like you will most likely have to get
another microwave oven, and do some modifications to the modeling, or find
one that fits, even if it is a little smaller.

If you venture in to a microwave oven, take care about the high voltage.
Even after the unit is shut down, there can be serious high voltage stored
in the main capacitor for the tube. As for the logic control board, the
voltages on that should not be lethal, except from the primary side of the
switching power supply.

I am guessing that we know someone here that will be getting some of his
kitchen redone...

--

JANA
_____


We have an Ewave (Daewoo/Magic Chef) KOT-152UW microwave oven purchased
at Home Depot. The touchpad is getting flakey and I have been trying to
locate a parts vendor without much success.

I'd appreciate any recommendations. Thank you.

(Yeah, I realise the touchpad may cost as much as a new oven but I
practically remoodeled the kitchen to fit this thing in.)
 
M

Mistress

Jan 1, 1970
0
This isn't much help, I'm afraid, but I'll post it because I'm sure
someone else will if I don't:

Be VERY careful working on this thing yourself. Uwaves are dangerous
to work on. I'm not talking about inadvertantly cooking your hand, I'm


Thanks. I'd thought about going on and on about my experience but I'm
not much for typing when I dont have to. We repaired microvaves (and
lots of other stuff) in my shop a couple decades ago.

And I recall one brief moment of folly that confirms the 'dangerous
shock' stuff. I reached for the HV cap in a live microwave. At that
moment the case wasn't particularly attached to the ground. I was.
 
Top