Maker Pro
Maker Pro

For Sale: Pace SX-70 hand piece with tips

Status
Not open for further replies.

Jotto

Aug 24, 2012
120
Joined
Aug 24, 2012
Messages
120
I don't use this hand set any longer. I changed to the SX-80 after years saying I didn't like it. These are solder extractor hand pieces.

Just tested the unit heats up fine and is complete to the main unit without the round filter at the MBT. If you know this unit, you will understand what I am saying.

Tips listed below.

1121-0368-P5 one in hand piece and 9 new ones
1121-0342-P5 5 each new
1121-0367-P5 2 each new

I think I have another hand piece somewhere, if I run across it, that will be included. I believe this one has a bad heating element. They are easy to replace if you want a back up. Might also have a extra glass tube.

I have a total of 3 SX-70, looks like one works fine, one seems to have a new heating element, third I think is bad heating element. I do have a new glass tube. The problem with the last two should be easy to fix, when plugged in to station they start the pump without depressing the switch. Heating element will run about 80.00 if you wish to fix the last one.

Sold
 
Last edited:
Status
Not open for further replies.
Top