P
[email protected]
- Jan 1, 1970
- 0
I use ORCAD Capture for schematic design only, not for any layout or
simulation, my revision is 10.0.0.
One schematic I am working on shows several downward pointing green
triangles. I can delete them, save and exit, but then when I reopen the
file they are back. Probably means some kind of error or violation, but
so far I sure as heck can't figure out what it is.
This is probably kind of a "green' question (pun intended), any advice,
guidance or solution appreciated.
simulation, my revision is 10.0.0.
One schematic I am working on shows several downward pointing green
triangles. I can delete them, save and exit, but then when I reopen the
file they are back. Probably means some kind of error or violation, but
so far I sure as heck can't figure out what it is.
This is probably kind of a "green' question (pun intended), any advice,
guidance or solution appreciated.
