T
Thunder
- Jan 1, 1970
- 0
Hello, I'm using Orcad 9.2 layout software. All the parts are laid out on
the board; however, when I attempt to manually route two pins together, the
entire screen turns blue (the color of the top layer which I'm using). To
get out of this mode, I need to undo the route step and refresh the screen.
This happened with another layout I was doing. I did successful routes and
unroutes (automatic)...then after placing some more parts, I get the blue
screen effect. Could I have inadvertently changed a setting? I seem to be
flooding the design with routes for some reason. Any suggestions?
the board; however, when I attempt to manually route two pins together, the
entire screen turns blue (the color of the top layer which I'm using). To
get out of this mode, I need to undo the route step and refresh the screen.
This happened with another layout I was doing. I did successful routes and
unroutes (automatic)...then after placing some more parts, I get the blue
screen effect. Could I have inadvertently changed a setting? I seem to be
flooding the design with routes for some reason. Any suggestions?
