Connect with us

Orcad Layout 10.3 Free Via Issue

Discussion in 'CAD' started by Matt, May 23, 2007.

Scroll to continue with content
  1. Matt

    Matt Guest

    Hello,

    I am trying to attach a copper area to my ground plane using VIAs. I
    lay several vias out and make sure their net is set to GND as well. I
    get a few down and they are all attached to the GND net then for some
    reason, my layout window minimizes and all the vias I had placed are
    no longer attached to any net. I can't seem to re attach the vias to
    the GND plane. Anyone else run into this issue?

    Thanks,
    Matt
     
  2. Marra

    Marra Guest

    Should have bought PCBCAD21 off ebay.
    That automatically creates powerplanes on each layer and connects them
    to the desired net.

    www.ckp-railways.talktalk.net/pcbcad21.htm
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-