Maker Pro
Maker Pro

Orcad capture part text

A

Active8

Jan 1, 1970
0
I tried setting my schematic preferences so that text is 10 pt font
and this works for most stuff.

I'd like the text for parts like sources to also have a larger font.
At my screen res, you can barely see that 7 pt font.

What can I do? Anything?

Ok. JT'll hopefully ignore this, but if not, sorry, I still haven't
gotten into PSpice Schematics :(
 
J

Jim Thompson

Jan 1, 1970
0
I tried setting my schematic preferences so that text is 10 pt font
and this works for most stuff.

I'd like the text for parts like sources to also have a larger font.
At my screen res, you can barely see that 7 pt font.

What can I do? Anything?

Ok. JT'll hopefully ignore this, but if not, sorry, I still haven't
gotten into PSpice Schematics :(

Now WHY would I say anything, Capture is JUST SO INTUITIVE ;-)

...Jim Thompson
 
B

Boris Mohar

Jan 1, 1970
0
I tried setting my schematic preferences so that text is 10 pt font
and this works for most stuff.

I'd like the text for parts like sources to also have a larger font.
At my screen res, you can barely see that 7 pt font.

What can I do? Anything?

If you have already drawn the schematic than do the following:

As an example I am assuming that you want to change the font for all part
values for instance.

CTRL-A select all
CTRL-E Mickey Mouse property editor will open
Select Parts tab
Left click on the Value header
Right click and select Display
Change whatever you like in there. If appropriate font size does not show
than type it in.

If you are starting a new design than go to Options, Design Template



Regards,

Boris Mohar

Got Knock? - see:
Viatrack Printed Circuit Designs http://www3.sympatico.ca/borism/
 
A

Active8

Jan 1, 1970
0
If you have already drawn the schematic than do the following:

As an example I am assuming that you want to change the font for all part
values for instance.

CTRL-A select all
CTRL-E Mickey Mouse property editor will open
Select Parts tab
Left click on the Value header
Right click and select Display
Change whatever you like in there. If appropriate font size does not show
than type it in.

Thanks. That does the job and the shortcuts are much appreciated.
If you are starting a new design than go to Options, Design Template
Ah. Template and dsgn props. Same but different. TNX again.
 
Top