J
John Dough
- Jan 1, 1970
- 0
I've got a schematic which I"ve setup with Orcad Layout and set it to single
sided. The bottom layer is set to routing and the top later set to jumper.
I've also set the jumper lengths under options. From what I've read the
auto route should now create jumpers when it can't find a route.
But its not working
What am I missing?
sided. The bottom layer is set to routing and the top later set to jumper.
I've also set the jumper lengths under options. From what I've read the
auto route should now create jumpers when it can't find a route.
But its not working
What am I missing?
