Maker Pro
Maker Pro

OpenOCD init Failed; Help

chuttney1

Jul 17, 2015
1
Joined
Jul 17, 2015
Messages
1
The title says it all. One thing to say before going into detail about the issue. I am a complete beginner at using the terminal in Ubuntu that I need help with the codes to fix this issue.

Long story short. Im trying to upload some firmware to a motor controller using an STM32F4 Discovery board since programming takes place with the ST-Link/V2 over SWD pins on the Discovery board. I accidentally forgot to remove the jumpers to allow upload to the motor controller and I don't know what happened to the board. It does not have blinking leds on the lower half of the board anymore as a result. The picture below show what I have been getting as of yesterday to upload firmware to the controller. I have done a test to see if connecting and not connect the controller would give this error. Doing both have resulted in this error. I'm try to fix this issue, but Sourceforge has been working well the past few hours.

iNpWzdV.png
 
Top