OMNI Pro II Zone Secure Issue

[DeputyDawg]

Hooked up 3 windows to the same Zone. To get an NOT READY ALL 3 Windows
have to be breached. How can I make it so that if only ONE is breached it
would show NOT READY? I wired all 3 together and then onto the single wire
running to the OMNI Pro II board.

 

[Crash Gordon]

YOu've got them in parallel, put them in series with each other...you really
should home run each window and make-up your loops in the panel - not buried
out in the field somewhere which is clunky to service.

ps. Dont cross post (post to more that one group at a time)

| Hooked up 3 windows to the same Zone. To get an NOT READY ALL 3 Windows
| have to be breached. How can I make it so that if only ONE is breached it
| would show NOT READY? I wired all 3 together and then onto the single
wire
| running to the OMNI Pro II board.
|
|
|

 

[[email protected]]

You'll need to wire them in series, no parallel.

 

[DeputyDawg]

Thanks. It did the trick.


::: You'll need to wire them in series, no parallel.