Connect with us

Old Radar Display, need info

Discussion in 'Electronic Design' started by Jacques St-Pierre, Feb 4, 2009.

Scroll to continue with content
  1. Hello,

    I need to power up an old Military Radar display unit build by Kelvin
    Hughes, code no RDS-A1, do any one know what was the supply voltage,
    frequency and power connector pinout?

    I suspect it may be 120Vac at 400Hz, but I am not sure. I also assume power
    input was going to the power switch, but I am not sure too. So any hint will
    be helpful at this point.

    Bye

    Jacques
     
  2. PeterD

    PeterD Guest


    Aircraft display, or ground display? There should be a tag (plate)
    indicating power requirements near the power input connector.
     
  3. Sadly, I can not find any tag (plate). What I suppose to be the power input
    is not even named, just a multipin military style connector. I figure it
    must be power input since the unit have no other connector (except video &
    sync). Two wires are route to the power switch, so they must be it, but no
    luck to power it from there, maybe the unit is also defective.

    Jacques
     
  4. PeterD

    PeterD Guest

    Consider posting images on a web site. Sides, back, front, covers
    removed.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-