Connect with us

OBD tester

Discussion in 'General Electronics Discussion' started by alstbernard, Apr 18, 2010.

Scroll to continue with content
  1. alstbernard

    alstbernard

    9
    0
    Apr 18, 2010
    I have an obd Innova3140 1and2 scan tool and i tried it on my Nissan car and it does not work is says 'link is not established' but it reads the protocol. When i used it on another car not a Nissan car it works.
     
  2. webman

    webman

    2
    0
    Apr 18, 2010
    I've got the same problem and just came across this to see if anyone had any suggestions, don't know if its the innova or the car that is faulty....
     
  3. (*steve*)

    (*steve*) ¡sǝpodᴉʇuɐ ǝɥʇ ɹɐǝɥd Moderator

    25,500
    2,840
    Jan 21, 2010
    Perhaps Nissan use a different protocol, or perhaps the thing you're using does not implement the full protocol?

    If two of you have the problem then it's unlikely to be either the car or the device (unless you're sharing) that's faulty. The issue is likely to be that they are simply incompatible.
     
  4. 55pilot

    55pilot

    434
    3
    Feb 23, 2010
    I would recommend posting this on a car repair forum or maybe a Nissan specific forum.

    ---55p
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-