Maker Pro
Maker Pro

nuts & volts article

E

electro phil

Jan 1, 1970
0
Hello, I am looking for the 3 axis stepper controller article out of
Nuts & Volts Magazine From May, June, July & August 1999 if anyone can
help me with a photocopy or scanned article. Or if anyone has
schematics and drawings for a 3 axis controller board to run from a
parallel port would be appreciated.
Philip
 
P

Parmin

Jan 1, 1970
0
"electro phil" <[email protected]> while reading the
NewsGroups, found courage and express out opinion in
Hello, I am looking for the 3 axis stepper controller article
out of Nuts & Volts Magazine From May, June, July & August 1999
if anyone can help me with a photocopy or scanned article. Or if
anyone has schematics and drawings for a 3 axis controller board
to run from a parallel port would be appreciated.
Philip

Try Oatley Electronics www.oatleyelectronics.com.au

Par.
 
Top