Connect with us

Not getting the desired output for the circuit given

Discussion in 'General Electronics Discussion' started by jazzycool, Jul 27, 2017.

Scroll to continue with content
  1. jazzycool

    jazzycool

    1
    0
    Jul 27, 2017
    Hello guys,
    I am trying to solve this lab for circuits class, but for some reason, the myDaq oscilloscope software is not showing the correct sine wave to find the question number 3 or 2 in the following image. The circuit I am trying to solve is also given in the following image with the given settings for the software.

    [​IMG]


    Here is the image of the circuit, I made sure the connections are right almost 10 times now. The op-amp number is - TL082

    [​IMG]

    Here is what I am getting with the settings and the circuit I have built.

    [​IMG]
     

    Attached Files:

  2. dorke

    dorke

    2,342
    665
    Jun 20, 2015
    Welcome to EP.
    1. It looks like one connection is missing in your circuit:
    Pin 1 and 2 of the IC are not connected as they should be,see below.

    2. notice the scope says "waiting for trigger",better put it in type="Auto trigger mode".

    3. You should use colors of Leds as shown in the paper.

    Pf7Tq.png
     
    Last edited: Jul 27, 2017
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-