Maker Pro
Maker Pro

nmix/t-0020 board layout

S

Scott Brehler

Jan 1, 1970
0
Hi all,

In my quest to get reaquainted with microprocessors I have recently aquired
an NMIX/T-00200 evaluation board (made by NewMicro) for working with the
MC68HC11 microprocessor. I have the user's manual via online, but the
document with the board's layout is very blurry and unreadable. I can't get
a copy from either the person that I purchased it from (via Ebay), or from
NewMicro (which hasn't returned my email inquiry). Does anyone have a copy
of the "data sheet" which shows this board's layout? Or, where I can obtain
one?

And...

Along with the board I got was an Xilinx XC3020 board. I'm assuming that
this is used to program the EEPROM on the 68HC11. (?) Anyone able to point
me in the right direction regarding using this board?

Again, basically I got the evaluation board in the hopes of doing some basic
assembly programming of the processor via my PC. Interfacing it via the
serial port of my PC. I got it for what I thought was cheap via Ebay and
probably didn't do enough homework before doing so... my bad! So, any help
from someone out there would be greatly appreciated!

Thanks for your input...(no pun intended)

Scott
 
R

Rich Grise

Jan 1, 1970
0
Hi all,

In my quest to get reaquainted with microprocessors I have recently aquired
an NMIX/T-00200 evaluation board (made by NewMicro) for working with the
MC68HC11 microprocessor. I have the user's manual via online, but the
document with the board's layout is very blurry and unreadable. I can't get
a copy from either the person that I purchased it from (via Ebay), or from
NewMicro (which hasn't returned my email inquiry). Does anyone have a copy
of the "data sheet" which shows this board's layout? Or, where I can obtain
one?

And...

Along with the board I got was an Xilinx XC3020 board. I'm assuming that
this is used to program the EEPROM on the 68HC11. (?) Anyone able to point
me in the right direction regarding using this board?

Again, basically I got the evaluation board in the hopes of doing some basic
assembly programming of the processor via my PC. Interfacing it via the
serial port of my PC. I got it for what I thought was cheap via Ebay and
probably didn't do enough homework before doing so... my bad! So, any help
from someone out there would be greatly appreciated!

Thanks for your input...(no pun intended)

If it's useless to you, that's arguably DOA, for all practical purposes -
does your seller have a DOA policy?

(DOA == Dead on Arrival).

Good Luck!
Rich
 
Top