Maker Pro
Maker Pro

Newer RCA 32" TV dead.

D

Dani

Jan 1, 1970
0
Made in mid 2006...refurbished, now dead again. RCA M # 32V434TYX5 Ch
# ATC 010A dead.
I found one of the springs on the CRT ground on the main board, & the
front audio/video jack wires were pinched in the back. Bad sets I
think! Nothing is blown, or damaged, but the SMPS isn't running.
Replaced both caps in the power supply, now, it tries to start, but
dies again. The secondaries try to come up, but drop right back down.
It seem the .68 uf @ 50 volt cap in the SMPS primary is very touchy
about the exact value. Can't find anything loading the secondaries.
The SMPS reg is a STRW6735. I have one on order. Anyone see these new
sets dead? What goes bad? Dani.
 
E

Emanuele Girlando

Jan 1, 1970
0
Made in mid 2006...refurbished, now dead again. RCA M # 32V434TYX5 Ch
# ATC 010A dead.
I found one of the springs on the CRT ground on the main board, & the
front audio/video jack wires were pinched in the back. Bad sets I
think! Nothing is blown, or damaged, but the SMPS isn't running.
Replaced both caps in the power supply, now, it tries to start, but
dies again. The secondaries try to come up, but drop right back down.
It seem the .68 uf @ 50 volt cap in the SMPS primary is very touchy
about the exact value. Can't find anything loading the secondaries.
The SMPS reg is a STRW6735. I have one on order. Anyone see these new
sets dead? What goes bad? Dani.

I don't know the model...
I would try to load the main SMPS secondary (the one providing
feedback to the primary section) with a filament lamp....
 
Top