Connect with us

Need help with wiring an electric motor

Discussion in 'Sensors and Actuators' started by kisuke47, Feb 28, 2018.

Scroll to continue with content
  1. kisuke47

    kisuke47

    1
    0
    Feb 28, 2018
    Hi I'm new to these forums and hope to get some help I have an old baldor motor I would like to wire up its a single phase ac motor I'm trying to wire it for 115 volts it has a wiring diagram on the motor it says connect wires 1 3 8 and wires 2 J 5 which I have already done each of the wires are in there respective groups connected with wire nuts in the pictures I have them up and out of the way so you can see better so my question is where do I connect my positive and negative wires too from my power cord? and what do I do with the number 4 wire that's just hanging there? any help would be great thanks.
     

    Attached Files:

  2. Bluejets

    Bluejets

    3,999
    826
    Oct 5, 2014
    Can't see the diagram and it is out of focus.

    Try like another poster did here, light the subject via other source and turn off the flash.

    Try to use some form of punctuation to make your request readable.
     
  3. Minder

    Minder

    2,948
    623
    Apr 24, 2015
    Line in is 1 and 4 .
    M.
     
  4. Tha fios agaibh

    Tha fios agaibh

    2,088
    699
    Aug 11, 2014
    L1 (hot) ties to 1,3 and 8
    L2 (Neutral) ties to 4
    2,5 and J tie together
    Don't forget the proper overload protection and ground.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-