Maker Pro
Maker Pro

need help with a strobe switch

monstermind

Jan 9, 2012
2
Joined
Jan 9, 2012
Messages
2
hi all,im wanting to build a small circuit that will connect two contact points to simulate a button press,would like to use a small pot to determine time intervals between button presses ,but it would mainly be in the ms region,is there a way to do this with electronic parts normally found in the home so as to recycle. all the advice is appreciated
 

(*steve*)

¡sǝpodᴉʇuɐ ǝɥʇ ɹɐǝɥd
Moderator
Jan 21, 2010
25,510
Joined
Jan 21, 2010
Messages
25,510
Explain the intended operation more fully:

1) what is the load being switched?
2) what range of delays are you looking for (ms, seconds, minutes, hours?)
3) presuming the first "button push" is the actuation of a momentary contact switch, and the second is the "simulated" button press, do you wish to also preserve the duration of the initial button press?
 
Top