Maker Pro
Maker Pro

Need help with a Amico multi-process welder

Raylicker

Oct 16, 2019
9
Joined
Oct 16, 2019
Messages
9
Hi all, do you or could you lead me to a group that can help me get this welder going. I left it on for about an hour and when I got back it was off and never to start again. The power light goes on but nothing else. The switch is good. Only had the thing for 1 year and then one month after the warranty expired it died. Thank you for any help here or point me to another group, I was told there was one that would help with troubleshooting PCB's. I'm getting power to the capacitors but don't know where o check after that. Here are pics of the two boards in it. Could it be on the little board? if I am getting power all the way to the capacitors, shouldn't I have front panel lights or something? Please any help, here are pics of both boards
 

Attachments

  • 003 - resized.jpg
    003 - resized.jpg
    299.2 KB · Views: 12
  • 004 - resized.jpg
    004 - resized.jpg
    221.7 KB · Views: 12
  • 005 - resized.jpg
    005 - resized.jpg
    308.4 KB · Views: 12
  • 005 resized.jpg
    005 resized.jpg
    341.4 KB · Views: 12
  • 006 resized.jpg
    006 resized.jpg
    531.4 KB · Views: 13
  • 20191106_154355resized.jpg
    20191106_154355resized.jpg
    141.4 KB · Views: 13
Top