Maker Pro
Maker Pro

Need help on this device Dc 5v 4-phase 5 wire stepper motor board + remote control

mrel

Jul 2, 2008
115
Joined
Jul 2, 2008
Messages
115
Hi
Purchase from ebay come with no instruction,device Dc 5v 4-phase 5 wire stepper motor board + remote control wireless RC.
Anyone on this forum know how hookup this device
Enclosed two pictures.
There is two connectors on the board don't know what is use for.
Thank for the help.
mrel
 

Attachments

  • IMG_20180824_161516.jpg
    IMG_20180824_161516.jpg
    171.8 KB · Views: 37
  • IMG_20180824_162510.jpg
    IMG_20180824_162510.jpg
    176.6 KB · Views: 44

kellys_eye

Jun 25, 2010
6,514
Joined
Jun 25, 2010
Messages
6,514
How not to take photos.......:rolleyes:

Anyway, where is the power connection? If we could 'see' the board we might be able to assist.
 

mrel

Jul 2, 2008
115
Joined
Jul 2, 2008
Messages
115
How not to take photos.......:rolleyes:

Anyway, where is the power connection? If we could 'see' the board we might be able to assist.
Look at picture (2) show the board show two connectors ,don't know which one is the power connector.
mrel
 

mrel

Jul 2, 2008
115
Joined
Jul 2, 2008
Messages
115
Look at picture (2) show the board show two connectors ,don't know which one is the power connector.
mrel

Look at picture (2) show the board show two connectors ,don't know which one is the power connector.
mrel
 

WHONOES

May 20, 2017
1,217
Joined
May 20, 2017
Messages
1,217
Reminds me of fuzzy logic. What ever happened to that??
 

kellys_eye

Jun 25, 2010
6,514
Joined
Jun 25, 2010
Messages
6,514
Look at picture (2) show the board show two connectors ,don't know which one is the power connector.
mrel
Hence my comment on the quality of the photo. If we could SEE the board we could figure out which connections are for power.
 

Bluejets

Oct 5, 2014
6,901
Joined
Oct 5, 2014
Messages
6,901
Try these....:)
 

Attachments

  • 2.jpg
    2.jpg
    17.6 KB · Views: 27
  • 3.jpg
    3.jpg
    142 KB · Views: 27
  • 1.jpg
    1.jpg
    21.9 KB · Views: 27
  • 4.jpg
    4.jpg
    43.9 KB · Views: 28

kellys_eye

Jun 25, 2010
6,514
Joined
Jun 25, 2010
Messages
6,514
Your supply to the board is correct but the stepper uses a separate supply input (motor power + and motor power -) and must also receive power - this can be a different supply than that of the +5V power to the board itself as many steppers operate at a voltage that is higher (up to 30V for example) than the actual board supply voltage.
 
Top