Connect with us

NEC Multisync 1810 LCD

Discussion in 'Electronic Repair' started by Mark, Jun 10, 2004.

Scroll to continue with content
  1. Mark

    Mark Guest

    Hi,

    I have a few of these monitors. They had blown pico fuses and shorted
    surface mount transistors on the inverter board. I replaced these and now
    they're working but they aren't displaying full screen vertically. I have a
    black area about 1/2 inch wide on both top and bottom of the screen.
    Obviously there are no adjustements for Vertical width on the LCD. I was
    wondering if there was something else that was wrong with the electronics or
    if it's just somekind of setup i'm overlooking.

    Anyway, if anyone has any experience with these screens or LCDs in general
    i'd really appreciate your help!

    Mark
     
  2. RubbishRat

    RubbishRat Guest

    Have you tried different resolution and/or frame refresh rates from the PC ?
    Get the correct driver file from the maker and make sure the graphics card
    recognises the monitor.
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-