Maker Pro
Maker Pro

NAPCO Magnum 1000e

NC Sailor

Feb 15, 2015
1
Joined
Feb 15, 2015
Messages
1
Hello - I have an old and NAPCO system that has sensors and connections running through the house and wondering if any of the sensors and related hardware are worth trying to setup with a new system or just replace the entire system

Anyone with previous experience or who might be interested in the parts let me know
 

Anon_LG

Jun 24, 2014
453
Joined
Jun 24, 2014
Messages
453
Provide picture/s of the board/s. If the components have clearly shown markings on them this is of help. Most of the components will be Surface Mount Design, not much use unless producing an end product/thin PCB design. It is likely you that you would be better of scraping the thing. There may however be useful sensors, such as pyroelectric infrared sensors (motion sensors), provide pictures and I could look. However if thinking of using these components in a design connected to mains power ensure you know what you are doing.

I hope this helps,
 
Top