Napco Gemini 9600 Keypad Times don't match Panel Times

[Michelle]

I have a Gemini 9600 panel that shows correct time in Quickloader under
"DST - Time Zone" but the keypads (two of them) are one hour ahead.

The time zones on the PC and in quickloader are correct. I've done the
"Status/Control" / "Set Clock" as well... but nothing seems to correct
the time on the keypads.

This is a system that has been up and running since last fall when it
was installed.

I've googled this error, but I can't find any solutions for this exact
problem.

Any ideas?

Thanks!

 

[Michelle]

I just set the time manually in the keypads so no need to work on this
one.. thanks

 

[Jim]

I have a Gemini 9600 panel that shows correct time in Quickloader under
"DST - Time Zone" but the keypads (two of them) are one hour ahead.

The time zones on the PC and in quickloader are correct. I've done the
"Status/Control" / "Set Clock" as well... but nothing seems to correct
the time on the keypads.

This is a system that has been up and running since last fall when it
was installed.

I've googled this error, but I can't find any solutions for this exact
problem.

Any ideas?

Thanks!

My idea is ...... don't show the time at the keypads.

After my first few installations with the Gemini series, and finding
that the client couldn't adjust the time without getting into the
dealer programing, I just don't put the time up on the keypads.

Like ..... who needs another freakin clock to set? Especially one on
their alarm system.