Moose Experts...

[Bob La Londe]

Got a Z1100 system II I need to upgrade the cell back unit on. It is
sending 4X2 so I shouldn't have any problems just plugging in a TG-4, but I
figured it would be nice to reprogram it to one of my low price lines and
change the account number. Its one of the accounts I picked up when I
bought out Desert Alarm. I can't find the file for this account anywhere.
I suspect I never got it with the rest of the files. So of course I'm stuck
not knowing the installer code. I do know several standard codes the old
guy used before he died, but on his non-standard panels (this is one) he
often would use a different installer code.

Anybody know a quick easy way to default/recover?

Please do not post it publicly in the group. Most who would be likely to
know this have my hotmail address anyway. Please send it there if you got a
solution.


--
The Security Consultant
Bob La Londe - Owner
849 S Ave C
Yuma, Az 85364

(928)782-9765 ofc
(928)782-7873 fax

 

[Bob La Londe]

Got a Z1100 system II I need to upgrade the cell back unit on. It is
sending 4X2 so I shouldn't have any problems just plugging in a TG-4, but I
figured it would be nice to reprogram it to one of my low price lines and
change the account number. Its one of the accounts I picked up when I
bought out Desert Alarm. I can't find the file for this account anywhere.
I suspect I never got it with the rest of the files. So of course I'm stuck
not knowing the installer code. I do know several standard codes the old
guy used before he died, but on his non-standard panels (this is one) he
often would use a different installer code.

Anybody know a quick easy way to default/recover?

Please do not post it publicly in the group. Most who would be likely to
know this have my hotmail address anyway. Please send it there if you got a
solution.

Ah, looks like I found the answer on page 31 of the installer manual.

 

[Rich]

I can send you manuals, and programming PFD's
[email protected]

 

[Mark Leuck]

Got a Z1100 system II I need to upgrade the cell back unit on. It is
sending 4X2 so I shouldn't have any problems just plugging in a TG-4, but I
figured it would be nice to reprogram it to one of my low price lines and
change the account number. Its one of the accounts I picked up when I
bought out Desert Alarm. I can't find the file for this account anywhere.
I suspect I never got it with the rest of the files. So of course I'm stuck
not knowing the installer code. I do know several standard codes the old
guy used before he died, but on his non-standard panels (this is one) he
often would use a different installer code.

Otherwise power the system down, hold the button while powering up then go
to 010# and re-enter the installer code


But the biggest problem you have is it's a Moose Z1100 system II

 

[Bob La Londe]

I can send you manuals, and programming PFD's
[email protected]

I got them.

Thanks.

 

[Bob La Londe]

but got

Ah, looks like I found the answer on page 31 of the installer manual.

Life is always more complicated than it would seem. It turns out there is
no phone line at all. The old installer had just thrown an Uplink 1500 on
the panel to communicate generic alarms.

The panel never actually was programmed to send any signals. All signals
came from the backup unit.

YUCK.