Connect with us

Mod Speakers To Power LED To Flash With The Music

Discussion in 'LEDs and Optoelectronics' started by A1Entertainment, Dec 27, 2012.

Scroll to continue with content
  1. A1Entertainment

    A1Entertainment

    1
    0
    Dec 27, 2012
    Hi all,

    I am after some help with regards to wiring some LED lights to my passive speakers. I used to have a pair of Skytec Speakers which had this feature installed however after they had been replaced several times I gave up on them.

    The link below shows these speakers in action and the LEDs are powered through the passive speakers via the Amp/Mixer desk I have also included a link for this below.

    Old Speakers


    Amp
    http://www.behringer.com/EN/Products/PMP6000.aspx

    New Speakers
    http://www.hifi-tower.co.uk/Auna-PW-252 ... _i2790.htm

    I know that the LEDs in the old speakers where powered by by the current being supplied from the amp to the speakers as no other power source was used and I would like to use the same feature on the new speakers. However I am sure that you are not able to just wire them directly to the speaker cables without going through some sort of resistor / electrical circuit. Would any of you have a wiring diagram that could help me with this mod? or advise what I should use and how they should be wired so that I can get the same sort of effect as the old speaker video.

    Your help with this would be very much appreciated.

    Thanks in advance! :D

    Kind Regards
    Steve
     
Ask a Question
Want to reply to this thread or ask your own question?
You'll need to choose a username for the site, which only take a couple of moments (here). After that, you can post your question and our members will help you out.
Electronics Point Logo
Continue to site
Quote of the day

-