Hello all,
My name is joe, this is my first post and a complete newbie to electronics,
I have a new project on the go and i have come across a stumbling block, let me explain.
I have purchased a couple of segways (chinese copy) called wind rover, which have in there time, been water damaged.
The motors i have tested them isolated and there ok,
So i put the rover back together to test the motor controllers, and after a trawl through the net i have learned these are actuated via a rf keyfob so i cant complete testing untill i enable the board.
Looking at the pcb the is an antenna, a crystal chip marked 6.7458m thats all i know, i will attach a couple of pics,
I think i need to either disable the on board module or find a remote on the right frequency to enable, i might be miles away with my thinking but you get the drift.
I would be very greatfull for any help as im about exhausted looking through the net, i know im not asking the correct question, thanks
My name is joe, this is my first post and a complete newbie to electronics,
I have a new project on the go and i have come across a stumbling block, let me explain.
I have purchased a couple of segways (chinese copy) called wind rover, which have in there time, been water damaged.
The motors i have tested them isolated and there ok,
So i put the rover back together to test the motor controllers, and after a trawl through the net i have learned these are actuated via a rf keyfob so i cant complete testing untill i enable the board.
Looking at the pcb the is an antenna, a crystal chip marked 6.7458m thats all i know, i will attach a couple of pics,
I think i need to either disable the on board module or find a remote on the right frequency to enable, i might be miles away with my thinking but you get the drift.
I would be very greatfull for any help as im about exhausted looking through the net, i know im not asking the correct question, thanks